Document toolboxDocument toolbox

07-05-20 Release 614

Firmware Status

Suitable for SA380 Mod State 2+

Centrix Approved

New Features

  • The SA380's JSON configuration can now be edited remotely using Centrix.

    • Note this is intended for expert users only. 

Access to new features in Centrix

Access to the new "Read/Write Config" and "Firmware" tabs in Centrix (shown below) is restricted by default, if you or your team require access to the features please contact mpec to get them enabled.


Bug Fixes

  • Fixed an issue where very large installations (specifically master-slave networks of eight SA380s) could result in a configuration file which was too large for the master logger to handle.



Â