Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

This guide describes how to connect a master slave network of loggers.

  • An SA380TX is the master logger.
  • loggers are connected together using RS485.
  • Up to 7 devices can be slaved from a single SA380TX
  • The TX can scan the bus on demand to auto-detect slaves.

Connection Arrangement

  1. Configuring an SA380TX-L as a slave logger

    1. Un-check the "Standalone" button in web config.

       

    2. For older loggers which don't have web config installed, using dPanel Desktop this can be achieved as below:
    3.  
  2. The VTI21 does not require any configuration.
  3. The SA380TX is configured using the following sequence of dialogues:

  • No labels