Page Comparison

...

1. Configuring an SA380TX-L as a slave logger

   1. Un-check the "Standalone" button in web config.

       

   2. For older loggers which don't have web config installed, using dPanel Desktop this can be achieved as below:
   3.  
2. The VTI21 does not require any configuration.
3. The SA380TX is configured using the following sequence of dialogues
   1. Enter the configuration screen
      Image AddedImage AddedImage Added
   2. Set the RS485 port for use with protobuf slaves:
      Image AddedImage Added
   3. Ask the logger to auto-detect connected slave units
      Image AddedImage Added
   4. review the connected slave units
      Image AddedImage Added
   5. Verify that the logger is connected to them
      Image Added
      
      

Related articles