The following is intended as reference only. It is not advisable that these steps be undertaken without guidance from MPEC or in-depth knowledge of the product.
Incorrect modification of any of the configuration files can result the SA-SSI data logger becoming unresponsive and non-operational.
The configuration on the SSI logger consists of several text files which can be edited on a PC. These need to be extracted from the logger, edited and then reinstated. It is possible to “brick” the logger if these files are edited incorrectly.
Required equipment:
- Blank USB stick
- PC (to edit configuration)
Saving configuration to USB
Remove the USB to serial converter and insert the USB stick into the logger.
Navigate to the configuration menu:
Enter the pass code (the default is 12345):
Select “Save Configuration To USB”:
The logger will write the configuration to the USB stick:
When it’s finished, click “OK”
Updating the configuration
The USB stick will contain a folder named config_XXXX where XXXX contains the logger’s serial number:
It will contain several files, as per the example below:
Before editing the configuration, take a backup copy!
When finished, save the file back to the USB stick.
Loading configuration from USB
First insert the USB stick into the logger.
Navigate to the configuration menu:
Enter the pass code (the default is 12345):
Select "Load Configuration From USB":
Confirm loading of the new configuration:
The logger MUST be restarted in order that the new configuration is used.
Wait for the logger to restart.