This firmware release contains the following improvements:
Capture performance
Greatly improved the logger’s ability to cope with multiple concurrent captures.
TX-L slave connection reliability improved
Fixes occasional spurious “Local slave buffer overflow” events
Digital initial states are sent on startup
A state change is no longer required for a channel to be visible in Centrix
“About” menu UI improvements:
Now shows the NTP state correctly
Only shows information for the protocol that is currently in use
Disabled transmission of syslog messages relating to the modem
These (and other syslog message codes) can be enabled or disabled in the logger’s XML config
This reduces the comms and disk load on the logger, and makes the syslog easier to browse in Centrix