| Table of Contents |
|---|
Introduction
The SA380TX-L datalogger can monitor up to eight EBITrack units at a time.
Hardware setup
Configuration
Web interface
Enter the logger's IP address into your browser:
...
Successful connection will show the loading screen first:
...
| Info |
|---|
| Leave any unused EBITrack entries with Key Number = 0. |
Specify whether the collected EBITrack data needs to be sent to the server. Tick "Send to Server" if so.
Once finished, press Set button to send the new configuration to the logger.
dPanel
Related articles
| Filter by label (Content by label) | ||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...
| hidden | true |
|---|
...
Related issues
...
Once the configuration is set, you will want to make sure that the EBITrack units are talking to the logger. To check that quickly, go to the Real-time tab and EBITrack:
then 
also press 
After a short while you will see the connected EBITrack units and the retrieved data:
dPanel
Select the appropriate connection type. If you connected the SA380TX-L logger to the computer with a USB cable, select USB:
and Press Connect 
dPanel shows the Real-time tab on startup, so at this point to will see the real-time on the logger.
Select the Configuration tab: 
First time dPanel will ask you whether you want to download the configuration from the logger. Select Yes:
We will focus on the EBITrack configuration frame:
To make the SA380TX-L to request data from the EBITrack unit, you need to know the EBITrack unit's KEY serial number.
Double-click on the Key number entries to change them. Leave the unused EBITrack units with Key Number = 0!
Also set whether the retrieved EBITrack samples need to be sent to the II server or not. (Tick or untick the box in Send to Server column)
Once finished with the EBITrack configuration, press "Set" button to send the new configuration to the logger:
You will have to see: 
Once the configuration is set, you will want to make sure that the EBITrack units are talking to the logger. To check that quickly, go to the Real-time tab and EBITrack:
then 
You will see the EBITrack units connected and the data have been sent to the logger:
