...
General Principal
...
Devices are configured by MPEC at manufacture according to the users specification and intended application.
...
For a new installation, MPEC will process the specific system configuration files provided by the customer and automatically generate a working configuration.
They will connect to the MPEC Centrix server which collates the data collected.
The primary configuration, interrogation and data download interface is provided by the Centrix system.
The S-LX does feature a basic local interface for:
On-site minor configuration changes
On-site detailed status information
On-site real-time data status
Ethernet Interfaces
In installations where the LAN interfaces are unused, MPEC have configured the following:
LAN 1 |
...
192.168.100.116/24 |
...
LAN 2 | No Connection |
Diagnostic Interface
Connection to the device configuration and interrogation interface can be made from a web browser browser: http://ip.address.of.device/
The username and password will be provided by MPEC during a support call.
Status Information
Display the health of critical S-LX services
...
Real Time Display
The present status of each logged channel:
...
Historic Data
Historic data may be found in the folder http://ip.address.of.device/usbdays/
...
Configuration
Configuration is ideally performed via Centrix, which can be accessed from any web enabled device including smart phone or tablet. There may however be a need to configure the device locally
Mobile devices not permitted in the equipment building
S-LX unable to connect to Centrix and requires cellular network configuration change
Cellular Network unavailable
...
Judicial Event Recording
| Info |
|---|
This is not currently supported. |
...
Press and hold the push button on the top of the device.
Wait for the USB storage light to turn on (indicating that it is safe for removal)
Remove the USB storage device
Replace with a "new" device.
System Power Down
The S-LX does not have internal battery backup. Removing power will cause the logger to shut down.
To safely power down the logger, the following procedures should take place:
Mains:
Turn the plug off by the switch and remove the plug from the socket.
Unscrew the retaining screws on the logger power connector and pull the connector out of the logger.
Busbar:
Disconnect the fuse that connects the logger to the busbar.
Unscrew the retaining screws on the logger power connector and pull the connector out of the logger.