Versions Compared

Old Version 14

changes.mady.by.user Mark Beeson (Deactivated)

Saved on

compared with

New Version 15

changes.mady.by.user Mark Beeson (Deactivated)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

1) Set the RS485 "owner" to "Bender". This tells the SA380TX what type of device is attached to the RS485 port

TOUCHSCREEN - CONFIG TOOLMenu→Configuration→RS485

Image Added

Image Added


2) Create a "Bender" slave unit. The SA380TX needs to be explicitly told about devices attached to the RS485 port. Remember, only a single isometer may be connected at any one time.TOUCHSCREEN - CONFIG TOOL

Menu→Configuration→TX Slaves

Image AddedImage Added

Image Added

3 ) Check that the "Slave" has been successfully created

...