...
| Syslog | Description | Example |
|---|---|---|
| Thread stopped | software Software failure or possible overload. | thread=DiskLogger,state=8 |
| Thread safety system restart | software Software failure or possible overload. | |
| Unexpected disk removal | Error: only for Internal | |
| Battery level low at startup | flat Flat battery; battery is not charging . Let the logger charge the battery for a few hours. If the error still shows, send the logger back to MPEC for battery replacement. | 2.9V |
| Event receiver overflow | system System is overloaded. | |
| Could not delete folder | File system error? | |
| Could not create file | Important for SA380: must have external | |
| Modem command failed | Serial port error; modem error. It is not an error during modem baud-rate detection! | |
| M Tx File processing failed | Slow comms (file has been removed since), file system error |
In case of system overload errors, it is a good idea to double-check the data collection settings. It is possible that the logger is collecting way too much data.
Acquire-on-change thresholds are the usual suspects. You may want to set the threshold higher.
GSM Modem
SA380TX
| Syslog | Description | Example |
|---|---|---|
| Modem power off | ||
| Modem power on | ||
| Modem command | AT commands | |
| Modem command failed | check "Modem command" to find what triggered the error | |
| GSM signal strength at turn on | ||
| Disconnecting RASdial | Ending GPRS connection | |
| RASdial disconnected | Important for SA380: must have external | |
| Creating RASdial entry | Have to add a number to Windows phone book to be able to call it with RasDial | |
| SIM registered to | Tells the network | |
| Could not reg. with GSM network | International Mobile Subscriber Identity; International Mobile Station Equipment Identity | |
| GSM IMSI/IMEI | International Mobile Subscriber Identity; International Mobile Station Equipment Identity | |
| Dialling RASdial entry | RasDial call; opening PPP connection; shows user,pass | |
| RASdial connected | RasDial succeded | |
| RASdial error | err=Remote Access Error Code | err=691 |
| New RASserve timeout | RAS server started; timeout restarted | |
| DCD inactive (call cleared down) | Modem data carrier line is down (connection lost) | |
| Disabling RAS server | RAS server stop | |
| DCD active (call connected) | TX2: Dialup has been called | |
| RING received | Dialup during GPRS session | |
| GPRS started | GPRS thread start | |
| GPRS ended | GPRS thread end | |
| Modem fallback wait | Modem didn't manage to register to network, falling back for 1 hour |
...