...
With Centrix, the default channel Id for a capture is predefined to match the loggers physical channel, and it is not necessary to change it. However on the Network Rail II, it is necessary to make sure that N-R and R-N captures, even from physically different channels, are logged using the same mimosa offset. Capture channel offsets on the II sit in the range 64-127 (however the logger will not enforce this).
Configuring Captures on the SA380 TX-L
The configuration on the SA380TX-L is performed using the web config tool. Note: The older d-Panel based configuration software is similar and the following guide still applicable.
Trigger Captures are displayed in the configuration page as below:
Adding a new capture
Clicking on the "+" symbol will bring up the capture configuration pane
This display (below) is divided into four sections, as illustrated.
The SA380TX-L is limited to a total of 12 captures, which and if both N-R and R-N swings are to be collected, this will cover 6 ends of points. A paired capture is used when direction information is to be passed to centrix, or the II.
Capture Channel
Temperature Recording
Trigger Configuration
| Info |
|---|
Related articles
...