/
Centrix R55 Release Notes

Centrix R55 Release Notes

Release VersionCentrix R55
Release Date (Staging)16 December 2015
Release Date (Production)Never released to production - R56 was released instead.
Summary
  • Performance improvements for virtual channels and alarms.

  • Slave logger channels can now easily be copied to Excel.

  • New mobile friendly version of the analogue histogram report.
  • Capture trace episode usability improvements
  • Points alarm wizard improvements

 

Copying Slave Logger Channels to Excel

You can now copy and paste from the slave logger channels window into Excel. This allow you to easily make a backup of the loggers channel configuration.

 

 

Capture Trace Episode Usability Improvements

There have been several usability improvements to the capture trace episodes interface:

  • The date and time has been split into two columns in the capture table to make it easier to read.
  • The samples column has been removed and replaced with a length in seconds value.
  • A separate graph is now used to show the episode rather than re-using the capture graph.
  • Episodes can now be located in existing capture traces to assist in the setup/training process for alarms.

You can access the capture episodes page from the menu item Captures > Capture Episodes.

When you enter the page you'll need to first need select a site from the drop down list (1). Once you have selected a site, the channel drop down list will be populated with any available capture channels on the site, this will typically be channels representing current or pressure for points (2). After selecting a capture channel you will see a list of capture traces in the table below. Select a capture trace from the table (3) to display the trace data on the graph on the right.

To create an episode, drag a selection on a section of the graph (1).