...
| Info |
|---|
The following applies to firmware version 751 and above. |
| Table of Contents |
|---|
Introduction
The logger requires an Internet connection to connect to the Centrix server. The logger can be configured in two modes:
- Ethernet only
- Ethernet with GSM fallbackGPRS fallback
Note: where the Ethernet cable has no physical connection the logger will fall-back to GPRS immediately. It will always try an Ethernet connection first if that is available.
The following notes describe the basic settings and how to view the current operating mode. It is strongly advised that before leaving site, the logger is restarted, and that the configuration is verified as described in the final section.
...
The connection state can be viewed from the status page which is accessed by selecting "Status" from the front screen:
Internet and Modem State
There are two relevant indicators displayed:
...
This will display a list of the current IP addresses associated with the logger.
Centrix Connection
The Centrix connection state is also shown on the status page:
...