Table of Contents

Introduction

The SA380TX-L datalogger can monitor up to eight EBITrack units at a time.

Hardware setup

Image RemovedImage Added

Image Added

Configuration

Web interface

Enter the logger's IP address into your browser:

Successful connection will show the loading screen first:

...

Type the serial numbers into EBITrack Unit Settings frame:

dPanel

Related articles

Filter by label (Content by label)
showLabels false max 5 spaces SSD sort modified showSpace false reverse true type page labels kb-how-to-article

Image Added

Specify whether the collected EBITrack data needs to be sent to the server. Tick "Send to Server" if so.

Once finished, press Set button to send the new configuration to the logger.

Image Added

Once the configuration is set, you will want to make sure that the EBITrack units are talking to the logger. To check that quickly, go to the Real-time tab and EBITrack:

Image Added then Image Added also press Image Added

After a short while you will see the connected EBITrack units and the retrieved data:

Image Added

dPanel

Select the appropriate connection type. If you connected the SA380TX-L logger to the computer with a USB cable, select USB: 

Image Added and Press Connect Image Added

dPanel shows the Real-time tab on startup, so at this point to will see the real-time on the logger.

Select the Configuration tab: Image Added

First time dPanel will ask you whether you want to download the configuration from the logger. Select Yes: 

Image Added

We will focus on the EBITrack configuration frame:

Image Added

To make the SA380TX-L to request data from the EBITrack unit, you need to know the EBITrack unit's KEY serial number.

Double-click on the Key number entries to change them. Leave the unused EBITrack units with Key Number = 0!

Also set whether the retrieved EBITrack samples need to be sent to the II server or not. (Tick or untick the box in Send to Server column)

Once finished with the EBITrack configuration, press "Set" button to send the new configuration to the logger:

Image Added You will have to see: Image Added

Once the configuration is set, you will want to make sure that the EBITrack units are talking to the logger. To check that quickly, go to the Real-time tab and EBITrack:

Image Added then Image Added

You will see the EBITrack units connected and the data have been sent to the logger:

Image Added