The logger can be configured in two modes:

...

The following notes describe the basic settings and how to view the current operating mode. It is strongly advised that before leaving site, the logger is restarted, and that the configuration is verified as described in the final section.

Configuration Pages

These are configured on the logger from the configuration page:

...

The default settings are as follows:

Ethernet Only Configuration

To disable the Modem (and power it down) Select "Power Modem" which will update the display as follows:

...

Where possible it's recommended that DHCP is used. An example configuration for a GSM setup is shown below:

Ethernet with GSM Fallback

The logger will always attempt to use the Ethernet port if it is connected. Where Ethernet is not available (or is failing to allow the logger to make a connection), it will fall back to using GSM. The "Power Modem" selection must be made, and the APN, Password and Username set. The following shows a correct configuration:

Finalising Configuration

To update the logger's configuration, select "Update":

...

You should reboot the logger once changes have been made, and ensure that the logger is operating as expected after the restart:

Viewing current connection state

The connection state can be viewed from the status page which is accessed by selecting "Status" from the front screen:

...

This will display a list of the current IP addresses associated with the logger.

Centrix Connection

The Centrix connection state is also shown on the status page:

...