Versions Compared

Old Version 46

changes.mady.by.user Mark Beeson (Deactivated)

Saved on

compared with

New Version 47

changes.mady.by.user Mark Beeson (Deactivated)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

2) Follow the instructions for SA380TX - Firmware Upgrade using dUpgrade using the firmware package just downloaded.

3) After firmware upgrade to the "stepping stone" version is complete, follow the instructions for SA380TX - Firmware Upgrade using Centrix



...







Anchor
A10
A10
A7: Upgrading a Mod State 3 or later SA380TX with a USB drive, first using the "Stepping Stone" .ZIP firmware package for USB drives ,then using  "NR-II Approved" .UPG firmware package

...

2) Follow the instructions for SA380TX - Firmware Upgrade from .UPG files using a USB Drive using the firmware package just downloaded.


...















Anchor
A15
A15
A15A10: Upgrading a Mod State 3 or later SA380TX  with Centrix, using the "Centrix Recommended" .UPG firmware package

Firmware Upgrade is fully integrating into the Centrix platform, follow the instructions for SA380TX - Firmware Upgrade using Centrix to perform the the upgrade


...

























Anchor
A16
A16
A16A11: Upgrading a Mod State 3 or later SA380TX with a USB drive, using the "NR-II Approved" .UPG firmware package

1) Visit the Mpec Firmware Downloads Page and download the firmware package with the following properties:

Image Added

  • For SA380TX MS3+
  • Firmware that is labelled "NR-II Approved".
  • Download the UPG File


Info

New firmware is released regularly, and approval status may change. Following the guidance above will always steer you towards the correct firmware package.

2) Follow the instructions for SA380TX - Firmware Upgrade from .UPG files using a USB Drive using the firmware package just downloaded.


...















Anchor
A18
A18
A18A12: Upgrading a Mod State 3 or later SA380TX with dUpgrade remotely, using the "NR-II Approved" .UPG firmware package

1) Visit the Mpec Firmware Downloads Page and download the firmware package with the following properties:

Image Added

  • For SA380TX MS3+
  • Firmware that is labelled "NR-II Approved".
  • Download the UPG File


Info

New firmware is released regularly, and approval status may change. Following the guidance above will always steer you towards the correct firmware package.

2) Follow the instructions for SA380TX - Firmware Upgrade using dUpgrade using the firmware package just downloaded.


...






...