Page Comparison

...

1. Configuring an SA380TX-L as a slave logger

   1. Un-check the "Standalone" button in web config.

       

   2. For older loggers which don't have web config installed, using dPanel Desktop this can be achieved as below:
   3.  
2. The VTI21 does not require any configuration.
3. The SA380TX is configured using the following sequence of dialogues
   1. Enter the configuration screen
        
   2. Set the RS485 port for use with protobuf slaves:
       
   3. Ask the logger to auto-detect connected slave units. This will take approximately 10 seconds.
      
   4. review the connected slave units. Each unit is dispayed on its own button which will contain the slave type when known, and the units serial number. In the example below, the first unit is of unknown type, and the second is a slave SA380TX-L. The MPEC slave system automatically allocates channels and input types, so it is not necessary for complete slave type identification.
       
   5. Verify that the logger is connected to them. Each logger will be shown connected with the "+UnitActive: X" moniker where the X represents the logger number. Logger "0" is the SA380TX master.
      
      
      
      

Related articles